【Troubleshooting】What Causes Yarbo Lights to Flash Different Colors Alternately, and How Can It be Addressed?

If you observe your Yarbo light consistently cycling through red-green-blue-white flashes, it may indicate an underlying issue. This troubleshooting guide is designed to assist you in identifying the potential causes behind the blinking and offers step-by-step solutions to address these problems.

1. Yarbo Connected to the Internet, Lights Still Flashing After Firmware Upgrade:

• Restart your Yarbo device.
• Utilize the Yarbo Tool to perform a deep clean for the disk memory.
• If the issue persists, contact us for support.

2. Yarbo Device Not Connected to the Internet, Lights Always Flashing Different Colors:

• Restart your Yarbo device.
• If the issue persists, use the Yarbo Tool to perform a deep clean for the disk memory.
• Connect to the internet and initiate the firmware upgrade process. The process could take at least one hour.
  
• Wait for the upgrade to finish. 
  
• Monitor for consistent operation.
• If the issue still persists, contact us for support.

3. Lights Flash Inconsistently Due to Power Interruption During Firmware Upgrade:

• Restart the Yarbo device and resume the firmware upgrade.

4. Lights Flash After Losing Network Connection During a Firmware Upgrade:

1. Restart the Yarbo device.
   
2. Reconnect to the internet, restart the upgrade, and monitor for consistent operation.
   

5. Lights Flash Without Recent Firmware Upgrades or Changes:

1. Restart your Yarbo device.
   
2. If the issue persists, use the Yarbo Tool to perform a deep clean for the disk memory.
   
3. Connect to the internet and initiate the firmware upgrade. Wait for the upgrade to finish.
   
4. Monitor for consistent operation.
   
5. If the issue still persists, contact us for support.
   

• Related Articles

• Troubleshooting Guide for Yarbo

  Please refer to the troubleshooting guide below when encountering any issues Please refer to the guidance The Yarbo Tool for fixing the internet connection

• 【Troubleshooting】What Should I Do if my RTK Base Flashes Green Light All the Time?

  If the LED on your Yarbo Base is flashing green, it may indeed indicate an issue with the Wi-Fi connection. The LED light will change to solid green once the RTK Base is connected to the Wi-Fi network. Please follow the steps below to connect your ...

• 【Troubleshooting】Rover Hotspot is Not Detected on Mobile Device

  Please refer to this article for assistance in case your Rover Hotspot not being detected on your mobile device, there are steps you can take to troubleshoot and resolve the issue. This guide will walk you through the process, and you can use the ...

• How to Fix the Common Issues with Yarbo Tool？

  The Yarbo Tool should be used in the following situations Connectivity Issues with both Yarbo device and RTK Base : The Yarbo app can not connect to the rover via the hotspot connection. 【Rover -> Network-> Wi-Fi Connection】 The hotspot of Yarbo's ...

• What are the steps to resolve typical problems encountered with the Yarbo Tool?

  The Yarbo Tool should be used in the following situations Connectivity Issues with both Yarbo device and RTK Base : The Yarbo app can not connect to the rover via the hotspot connection. 【Rover -> Network-> Wi-Fi Connection】 The hotspot of Yarbo's ...